IgentForm – Prestressed plates

– Possibility to define prestressing tendons:

with high and low points and manual definition of eccentricities in the Z direction

by selecting the start and end of the tendon and automatic generation of high and low points based on the static schema of the plate

– Possibility to export tendon to IgentBeam for optimization

– Possibility to import an optimized tendon, possibly including straight segments and the position of inflection points

– Automatic calculation of loads from a tendon

– Automatic creation of a load case <Compression> and display of loads after selecting this case

– Possibility to export loads from tendons to Autodesk Robot Structural Analysis

image1

About the Author: intelform.webmaster

Leave A Reply

Your email address will not be published. Required fields are marked *

Loading...