Possibility to specify the length of parallel bars( when reinforcing openings) as a total length (as an alternative to the length beyond the edge) – this facilitates the reinforcement of similar openings with bars of the same length Possibility to place a description line of a group of bars outside the dimensions of a representative […]
IgentForm – Continuous footings
Continuous footings – possibility of selection in the 3D view, changing the cross-section and type for any continuous footing, adding to the <Storeys> branch in the inspector window, results of simplified calculations in the calculation note
IgentForm – new possibilities
Calculation note – results of simplified calculations for columns, walls and spread footings Spread footings – possibility of selection in the 3D view, changing the cross-section and type for any footing, adding to the <Storeys> branch in the inspector window
IgentDraw – Pier reinforcement in footing drawing
Possibility to reinforce pier in footing has been added
IgentDraw – drawings of spread footings
Possibility to generate spread footing drawings has been added – Bottom and top reinforcement – Dowel bars for rectangular and circular columns Correction of noticed errors
IgentForm & IgentDraw – new options
Possibility to display elements by storeys (inspector window / Storeys). Items are automatically updated after each modification Consideration of columns when recognizing the static schema for prestressing tendons (IgentForm)
IgentForm & IgentBeam – Prestressed structures (improvements)
Possibility to visualize the covers of prestressing tendons – CMF system (The trajectory of covers is calculated automatically based on the location of high and low points and the eccentricity) Adding information about the trajectory of the tendons and tendon covers to the calculation note Display of the diagram of compressive stresses in concrete (IgentBeam)
IgentForm & IgentDraw – new possibilities
Possibility to run most options also from the top menu Possibility to add elements (beams, columns, walls, wall openings) graphically
IgentForm – automatic model generation from DXF background
The possibility of automatic generation of the model after assigning elements to layers (elements must be defined in axes)
IgentForm & IgentDraw – new possibilities
Common options for IgentForm and IgentDraw Interface improvement (more readable font, controls shape) Possibility to define rectangular and radial grids and taken them into account as snap points Line length displaying Correction of reported and noticed problems Options in IgentForm program Possibility to add elements in axial mode(beams, columns, wall, openings in walls) Possibility to […]