1) IgentForm – Calculation of theoretical reinforcement areas for beams and columns

2) IgentForm – Consideration of distributed loads from slabs after calculations using the LTD method in FEM calculations (Robot)

3) IgentForm – Possibility to define support stiffness for rotation (reduction of bending moments)

4) IgentForm – Display of a table with detailed results for beams and columns (bending moments, shear forces, theoretical reinforcement areas)

5) Calculator of theoretical reinforcement areas (compression, bending, compression with uniaxial bending, shear) according to BAEL91 mod.99 and EN-1991-1-1

6) IgentDraw – Import of theoretical reinforcement areas for columns from IgentForm

7) IgentDraw – Display of actual reinforcement areas for columns for a given reinforcement scheme

8) IgentForm – Possibility to specify horizontal offset for beams

8) IgentForm – Possibility to automatically calculate gamma angles for columns if they are on a curve

9) IgentForm – Possibility to specify different elevation layouts and materials for different floors in the same solid

10) IgentForm – Possibility to position a group of openings consisting of several openings relative to the center of the group

11) IgentForm – Possibility to generate columns placed on the contour lines of the solid and corner columns as vertical columns over the entire height of the solid

12) IgentForm – Possibility to disable wall generation on any level of the solid

13) IgentForm – Possibility to automatically generate balconies

14) IgentForm – Possibility to analyze the solar energy reaching the building and optimize it based on the position of the building relative to the coordinate system.

15) Correction of found and reported errors