Possibility of independent definition of places of division of top reinforcement bars in the case of their length greater than maximum length Possibility to generate anti-shrinkage reinforcement Possibility to use different diameters in the first layer of reinforcement Designation of the beam level in the drawing
IgentDraw – new options
Cutting opening reinforcement to other openings Arranging drawings of beams vertically Optimization of the beam reinforcement type – possibility to set the number of bars directly in the beam Possibility to define the number of elements for slabs and walls Problems correction – no stirrups in the Y direction for the opening close to the edge […]
IgentDraw – beam reinforcement (functionality improvement)
Including plates in the cross-section drawing Bar division for bar lengths greater than the commercial length Correction of noticed errors
IgentDraw – lintel reinforcement
Possibility to generate reinforcement in lintels
IgentDraw – walls reinforcement
Possibility to generate a stirrup as edge reinforcement at openings. Option <Maximum width >enables the generation of a stirrup between the openings instead of U bars
IgentDraw – new possibilities
Saving of transversal reinforcement on a separate layer for beams and columns when exporting to DXF Possibility to select regions by region type as well as reinforcement type and bar shapes in the case of slabs
IgentDraw – functionality improvement
Fatal program error after switching on additional reinforcement Optimization of the display of reinforcement maps Possibility to set bar laps independently for each region
IgentDraw – wall reinforcement based on DXF background
Possibility of adding wall elevations based on DXF background has been added, with the option of generating walls lying on many storeys on one facade and automatically connecting them with dowel bars, that take into account the openings in the wall on the higher storey and potentially different position of its ends in relation to the wall on the […]
IgentForm – structure axes
Possibility to display structure axes on 3D view has been added. Axes are generated automatically at characteristic points of structural elements. The option significantly improves the general orientation in the model, and when creating a model from a DXF background, it enables quick detection of inaccuracies that may cause calculation problems
IgentForm – new possibilities
Openings on the elevation – functionality improvement (removal of the selected opening according to the focus in the control, the possibility of extracting the opening from a group of openings for later modification) Plates – possibility of dividing, assigning different thicknesses and adjusting vertically within one mass Possibility to define railing on mass upper level