A new type has been added to the structure generator – Telecommunications tower
IgentForm – IFC export
Colors export to IFC file Possibility to export a story in the architectural mode (assigning the bottom slab to a story)
IgentForm – new program logo
Program logo has been changed –
IgentDraw – new possibilities
Setting the font size for the bar description Cutting parallel bars for reinforcement of the opening to the mass contour (important for reinforcement of a door in a wall) Selection of opening corners for reinforcement with sloped bars (important for reinforcement of a door in a wall)
IgentForm & IgentDraw – improvements
New point input modes during contour definition: – Project orthogonally entered points on the coordinate system axes The option allows entering any contours with perpendicular sides – Create the entered point orthogonally based on the last and two points clicked The option allows, f.ex.closing the contour with two perpendicular lines Point input modes can be scrolled back […]
IgentForm – new possibilities
Display of hatched sections of already defined columns in 2D view. This is especially helpful when adding columns based on a DXF background Significantly increased functionality when adding walls based on a DXF background – possibility of automatic selection of collinear lines creating walls and recognition of openings – the option of narrowing the selection […]
IgentForm – Facade modelisation
The option of quick definition of typical facades using a dedicated set of parameters and export to Autodesk Robot Structural Analaysis has been added A video showing this feature is available on the IgentForm channel at https://youtu.be/-Xt0UcPW-vg
IgentDraw – shaft reinforcement
Possibility of automatic generation of reinforcement drawings for shafts in foundation slabs. After defining the contour of the shaft hole and specifying parameters (shaft height, wall width, spacing and bar diameters), the program automatically generates all necessary reinforcement regionsand sets the appropriate parameters. When reinforcement is turned on, drawings are created automatically. A video demonstrating […]
IgentDraw – Reinforcement of walls
Possibility to extend reinforcement bars beyond the upper edge (used when it is necessary to release dowel bars to the wall above)
IgentDraw – bars division
Possibility to force the division of bars when their length is smaller than the maximum length (e.g. in the case of vertical bars in the wall)