1) IgentForm – possibility to define slab thickenings (usually over columns to correct punching shear conditions)

2) IgentForm – possibility to verify the punching shear condition for slabs with prestressing tendons

3) IgentDraw – possibility to automatically adjust column reinforcement to theoretical surfaces. This applies to model importedfrom IgentForm as well as manually entering reinforcement areas in IgentDraw

4) IgentBeam – support for extreme support types (fixed, pinned)

5) IgentDraw – automatic selection of beam scheme when activating beam reinforcement (number of spans, type of extreme supports)

6) IgentDraw – possibility to automatically adjust beam reinforcement to theoretical surfaces. This applies to model imported from IgentForm as well as manually entering reinforcement areas in IgentDraw

7) IgentDraw – possibility to define reinforcement patterns for beams.

8) IgentForm possibility to display bending moment diagrams on beams due to horizontal loads (seismic, wind).

9) IgentForm – possibility to add support moments to pinned beams as percentage of moment in span. This applies to the negative part of the envelope.

10) IgentForm – possibility to reduce bending moments, shear forces, and theoretical reinforcement areas in beams to the face of the supports.